Magnet-MAX麦吉克斯 SED-LDB 系列漏电流传感器

品牌 Magnet-MAX 麦吉克斯

分类 电流传感器

  • 产品详情
  • 附件下载

SED-LDB系列漏电流传感器

SED-LDB Series Leakage Current Sensor


电气特性/Electrical Characteristics
型号Type额定测量电流IPN(mA)Rated input current测量范围IPM(mA)Measuring current range
SED-0.01LDB1/LDB21015
SED-0.02LDB1/LDB22030
SED-0.05LDB1/LDB25075
SED-0.1LDB1/LDB2100150
VCC电源电压1)Supply voltage@DC ±12V~±15V ±5%V
ICC电流消耗Current consumption@IPN ≤15mA
VOUT额定输出电压Rated output voltage@ 25℃ ±5V
备注/note:1) 工作在±12V≤VC≤±15V会影响产品的测量范围.Operating at ±12V≤VC≤±15V will reduce the measuring range.
动态特性/Dynamic Characteristics
XG精度Accuracy@IPN,T=25℃ ≤±1%
ƐL线性度3)Linearity@IPN,T=25℃ ≤±1%
VOE零点失调电压VOEZero offset voltage@IP=0,T=25℃ ≤±20mV
VOM磁滞电压Magnetic offset voltage@IPN→0,T=25℃ ≤±20mV
TCVOE偏移电压温漂IOTTemperature variation of VOE@-40℃~80℃ ≤±2.0mV/℃
Tr响应时间Response time@90%IPN ≤50ms
BW工作频宽 -3dBBandwidthDC~50KHz
一般特性/General characteristics
TA工作温度Operating temperature-40~+85℃
TS储存温度Storage temperature-45~+85℃
m产品重量Mass(approx)≈65g
隔离特性/ Insulation coordination
Vd绝缘电压Galvanic isolation@50HZ, 1min 3.0KV


备注/note:

2)      线性度测试数据不包含零点失调电压. Linearity data exclude the electrical offset (VOE)

结构图/ Structure diagram


主要尺寸/Main dimensions


使用说明/Directions for use

●按照结构图中的电流箭头标定的方向接入电流,注意电流的正反向。/Please install according to the direction of the arrow in the structure diagram, and pay attention to the positive and reverse direction of current.

●按照结构图中标定的功能管脚定义来接线(注意:错误的接线可能导致传感器损坏)。/Please wire according to the definition of the functional pin illustrated in the structure diagram (Note: the inaccurate way of installation may cause damage to the sensor).

●初级导体的温度不应超过100℃。/Temperature of the primary conductor should not exceed 100°C.

●上述的规格为标准规格,我司可根据客户要求定制产品。/This is a standard mode. We can provide the products according to your specifications.



技术参数

规格项参数值
测量技术磁通门;磁阻式;霍尔效应;电感应式;其它
测量范围0-100000 amps
精度1/10000
电流类型交流;直流
环路类型开环;闭环
分享
收藏
拨打电话
立即沟通

1.点击右上角

2.分享到“朋友圈”或“发送给好友”

×

微信扫一扫,分享到朋友圈

推荐使用浏览器内置分享功能

  • #{subject}
    #{size}
    下载